Data Rate: 0 to
1200bps asynchronous over unconditioned lines
Operation:
Full duplex over 4 wire private lines or half duplex over
2-wire private lines
Modulation:
Phase coherent, frequency shift keyed (FSK)
Carrier
Frequencies:
Mark: 1200 Hz Space: 2200 Hz
Line
Impedance: 600 ohms 10%
transformer coupled and transient protected
Transmitter
Output Level: Selectable from 0,
to -12
dbm in 2 dbm steps
Clear to Send
Delay: 8.3 ms, 33.2 ms, 59.9 ms,
or 219.6 ms (selectable)
Carrier
Detect Delay: 6 ms or 23 ms
Digital Interface: EIA RS-232 (DB-25 female) and
CCI1l V.24
Teleco
Interface: RJ45 female
Turnaround
Squelch: 0 ms, 8.3 ms, or 159.6 ms
Anti
Streaming: 4, 7.6, 14, 28, 56,
none (selectable)
Soft Carrier
Turnoff: 0 ms, 8.3 ms, or 26.6 ms |
Environmental:
0 to 50° C; 95% humidity, noncondensing
Mechanical:
Width: 7"; Height 2.25";
Depth: 9.60"; Weight 3.0 Lbs.
AC Power
Requirement:115 VAC single
phase, 47 to 63 Hz @ 10 watts maximum
DC
Power Requirements: 12 to
60 VDC
Certification:
FCC Rules, Part 15 certified, CSA certified, DOC
certified
CS (Clear
to Send): ON when the CS line
is high (ON)
CD
(Carrier Detect): ON when a
carrier is detected by the modem receiver.
RD
(Receive Data): On when data
is received, decoded, and furnished to the terminal
equipment. RD is also ON when the receive cats line goes
into a space condition, OFF in a mark condition.
TD
(Transmit Data): Responds in
the same manner as the RD LED, but only when data to be
"transmitted" is furnished to the modem. However, the
LED may be on when the DTE is disconnected.
TM (Test
mode): Active when Test switch
is in any test mode. The indicate' will blink OFF/ON
when errors occur in Self Test mode
POWER:
ON when power is applied
|